Pro-Clad™ can be used as a total or partial clad solution.
On areas where brick slips need to be built adjacent to traditional brickwork, consistency of colour and finish can be maintained by ensuring bricks are collected from site, cut down in thickness before being fabricated onto the lightweight backing boards using a Approved Resin manufactured to BBA Certified processes. |
Pro-Clad™ backing boards have been developed to have a low environmental impact and are Non-Combustible, suitable for internal or external use. The backing board incorporates a mesh layer to improve its strength and its ability to withstand impact without increasing the overall panel thickness.
It is resistant to water, rodents and mould in addition to its thermal and sound insulation properties. It is easy to work with and can be cut on site using a hand-held angle grinder fitted with a diamond tipped blade with appropriate PPE. It is chemically stable and Non Hazardous. |
![]()
|
The Pro-Clad Range
PRO-CLAD 1 / Our rectangular brick faced cladding system where the slips between the adjoining panels are fabricated on site once the panels have been installed, more suited to vertical wall areas were repetition in the panel size is required, whilst the panels are still 95% off site fabricated. The pro-clad 1 is our most competitive brick faced cladding panel system
|
PRO-CLAD 2 / Our interlocking cladding panel system where no on site fabrication of slips is required, suitable for vertical and soffit application the PC2 system is usually designed site specific to fit the areas required.
|
PRO-CLAD 3 / Developed from our PC2 system but with the addition of a mechanical fix to each slip alongside the resin bonded adhesion of the brick slips to our carry panel.
|